Tilhenger med arbeidsplattform

MÜLLER-MITTELTAL T3 Tiefl., verz., Baggerstiel, hydr. Klapprampen

* T 3:
* EBS braking system
* Emergency release device for spring accumulators
* Drum brakes
* 3 x 11 tons BPW Eco axles
* Parabolic springs
* Mechanical axle compensation at the rear
Knsdpfxoq Dyv Is Ahuoa
* Side impact protection
* Swivel supports at the rear on the chassis frame
* Mechanically adjustable warning sign packages at the front and rear
* Front axle with closed plastic fenders and rear axle with straight, galvanized steel splash guards, each with splash protection
* Reflective contour strip on the sides and rear
* Hinged cover (hot-dip galvanized) for the toolbox in the turntable platform
* Toolbox made of galvanized sheet steel, approx. 650 x 300 x 600 mm - black powder coated - mounted on the side under the chassis
* 15-pole power connector
* LED lighting 12 / 24 V
* LED rotating beacon (removable) at the rear
* Drawbar with 40 mm towing eye and height adjustment via coil spring and tension lock
* 4 lashing pockets on each side (but no lashing bars included) with simultaneous lashing capability
* La-Si package consisting of: 2 lashing eyes (6.4 tons) at the front left and right on the main frame of the turntable platform
* 5 pairs of UVV lashing rings, swivel and lowerable
* Loadable in all directions and embedded in the outer frame in the corners, 13.4 tons, otherwise 10 tons
* 6 pairs of mechanical folding outriggers for a total width of 3 m (but not in the rear slope)
* Extension boards under the loading area, stored in a storage compartment
* Excavator arm support over the rear axle up to the end member, approx. 2,100 mm long (2 pairs of 6.4 tons lashing rings on the side in the excavator arm support)
* Hydraulic folding ramps (approx. 4,650 x 720 mm) with hydraulically extendable front section and load-holding check valves, hydraulic side ramp adjustment
* Hydraulic flow divider in the trailer (for hydraulic pump output in the truck of over 40 liters up to max. 140 liters / min), dual-line hydraulics
* Loading area above the slewing ring: approx. 1,960 x 2,520 mm
* Rear loading area: approx. 6,500 x 2,520 mm (incl. 860 mm approach ramp)
* Loading height when loaded approx. 860 mm +/- 30 mm compensating unit
* Chassis, turntable, folding outriggers, rear support legs and loading ramps hot-dip galvanized.
* Axles, springs, drawbar, air tank, etc. painted in a black tone
* New vehicle with manufacturer's warranty
* Errors and prior sale are subject to change
* Available for immediate delivery from Egestorf

Annonsen ble oversatt automatisk. Oversettelsesfeil kan forekomme.