Lavtlaster tilhenger

MÜLLER-MITTELTAL 24 to. Kombi Cont. fl.-Liftachse NEU

* TRA-Kombi 24.0:

----Braking System:

* Wabco EBS-E (electronic braking system)
* Emergency release device for spring-loaded cylinders
* Drum brakes

----Suspension:

* Air suspension with manual lowering at the rear

----Axles:

* 3 x 11 t Gigant axles
* Centre axle liftable

----Drawbar:

* Pneumatically lowerable drawbar, 2,100 mm in length with 40 mm draw eye & height adjustment device

Fsdpfxetplv Ts Afrsft
----Electrics / Lighting:

* LED tail lights
* 15-pin electrical connector
* TPMS (Tire Pressure Monitoring System)

----General Attachments:

* Toolbox made of powder-coated sheet steel (W: 1,000 mm x H: 300 mm x D: 450 mm)
* Storage box for container nets made of galvanized sheet steel (W: 960 mm x H: 300 mm x D: 450 mm)
* Side underrun protection
* Plastic quarter mudguards with splash protection
* Rear plastic impact protection buffers
* Mechanical drop-down rear supports

----Container / Low-loader Platform:

* Hot-dip galvanized main frame with raised outer frame (approx. 25 mm higher) for guiding roll-off containers
* Steel floor with roller recesses in the bogie area
* For roll-off container transport, container length from 5,500 to 7,000 mm possible
* Pneumatic 4-point clamp locking as well as mechanically insertable stop angles at the front of the tracks
* Load certification according to DIN 30722-1
* Transport of up to 2 skip containers with a maximum volume of 10 m³ possible
* 8 movable skip stops for lateral centering of the skips, front 4 stops inserted with pivoting stop

----Load Securing:

* 3 pairs of 10 t UVV lashing rings on the sides for attaching tie-down equipment for positive and non-positive securing of the skips
* 4 cloverleaf lashing points on each side and 1 pair of 13.4 t UVV lashing rings to the front
* Load securing certificate according to DIN EN 12195-1, DIN EN 12640, DIN EN 12642, and VDI 2700

----Ramps:

* Welded anti-slip bead in the running rails of the loading ramp
* 1 pair of aluminium approach ramps (16 t/pair) 2,800 x 400 mm, suitable for rubber-tired and tracked vehicles (lockable storage compartment accessible from the rear)

----Tyres:

* Tyres: 235/75 R17.5

----Coupling Height:

* Loaded coupling height approx. 1,003 mm

----Payload:

* Payload 18,900 kg

----Paintwork:
* Reflective contour tape on sides & rear
* Axles, turntable, drawbar and air tanks painted in black tone
* Main frame hot-dip galvanized

----Additional Information:
* Permissible gross weight of 27,000 kg technically possible
* New vehicle without initial registration with manufacturer's warranty
* Errors and intermediate sale reserved

----Delivery Time:
* Available from week 20/2026

Annonsen ble oversatt automatisk. Oversettelsesfeil kan forekomme.