Lavtlaster tilhenger

FLIEGL TPS 118 Bau mit Heckan Tandem Plattf Rampen

Total length: 8,000 mm
Kdjdpfx Adsyl E Dqexjh
Loading length: 6,200 mm including rear chamfer
Further information
plus freight / provision from stock location 26639 Wiesmoor €1,280.00 net

Loading width: 2,480 mm
Chassis: central axle trailer
Fine-grain steel welded construction
Outer frame, slightly angled, new version with “Load-Lock profile” for lashing strap attachment
Pair of lashing rings on the outside base, each 5 t
1 x in the front corners, 1 x in front of and 1 x in the rear chamfer at the back
6 pairs of lashing rings on the outer floor/frame, each 5 t
Gear support leg at the front
Rear support, foldable
Wheel chocks with holder
Aluminum side underrun protection
Galvanized steel rear underrun guard
Full-width rear spray flaps (not in conjunction with forklift mount)
Quarter-circle mudguards
1 plastic toolbox, w=600 / h=425 / d=460 mm, lockable
Towing device for central axle trailer
Drawbar with tested 40 mm towing eye
Drawbar height-adjustable via spindle, max. adjustment range 300 mm
Axles & suspension
GFA or BPW axles according to manufacturer’s choice, with tapered roller bearings and S-cam brakes
"Axle/chassis laser alignment" reduces tire wear and fuel consumption
Parabolic suspension with maintenance-free steel-rubber mounting and mechanical axle load equalizing (rocker equalizer)
Braking system
2-line compressed-air braking system
Color-coded piping for easy service
Hand-spindle parking brake
2 non-interchangeable coupling heads at the front, with connection lines to the towing vehicle
24 volt ABS and ALB, with ABS plug at the front, with connection cable
Attention: The trailer may only be towed by towing vehicles that guarantee proper functioning of the ABS!
Wheels and Tires
235/75 R17.5, make as per manufacturer’s choice
Steel rims, factory silver
Electrics
24 volt, multi-chamber lamps, side yellow LED lighting
2 white position lamps at the front (LED)
2 white/red marker lamps at the rear
2 x 7-pin non-interchangeable plugs at the front, with connection cable
Floor
Steel/chequer plate floor for high point load capacity
Note: Slight floor waviness due to welding distortion possible!
Platform length approx. 6,200 mm
Rear chamfer approx. 900 mm
Front bulkhead / corner stakes
25 mm aluminum hollow section, 400 mm high
Side walls
25 mm aluminum hollow section, 400 mm high, foldable and removable
Intermediate posts
Without intermediate posts
Rear wall / rear corner posts
1 pair of steel posts attached to the frame, with holder to lock the loading ramps, entry width approx. 2,430 mm
Loading ramps
Steel ramps, 2,300 mm long, 510 mm wide, laterally adjustable
With carrying handle on the ramps
With wooden covering (tip area with steel/chequer plate)
With gas strut for single-person operation
Operating Notes
The specified gross weight is technically feasible; depending on the cargo, the gross weight may not be achievable while adhering to permissible axle, support, and kingpin loads. (Poor driving and tracking properties possible with incorrect load distribution)
Country of registration / plates
Germany
With Dekra inspection and certificate (according to §13 EC - FGV)
24/7 service hotline
Prepared for single-line license plate holder
Contour marking with reflective strips as per ECE R 048, white at the sides, red at the rear
Paintwork
Frame: DB 7350 Novagrau
Front bulkhead: aluminum
Side walls: aluminum, anodized
Loading ramps: hot-dip galvanized

Annonsen ble oversatt automatisk. Oversettelsesfeil kan forekomme.