Lav laster

Fliegl DTS 300 P

Further information
Chassis low loader trailer
Welded steel construction
Turntable with strong ball bearing slewing ring, storage box embedded in turntable front end
Folding rear support
2 wheel chocks with holder
Aluminum side collision protection
Rear spray flaps across the entire width
Widenings can be extended to 3,000 mm (not in the rear slope)
(However, the track width of the construction machinery or vehicles to be transported must not exceed the outer frame width of 2,550 mm)
Storage compartment for wooden planks in the middle of the cargo bed
Wooden planks 70 mm for widening to 3000 mm
Low loader lashing eyes
3 pairs of lashing points each 10 to integrated in the floor at the front
6 pairs of lashing points at the top and sides, each 10 tons, integrated in the outer frame
1 x to the neck area
remaining distributed in between Spacing not greater than 1200 mm
1 x rear slope
5 pairs of stake pockets embedded in the outer frame, inside 70 x 40 mm, (can be converted to 5 to. ring lashing eyes, not included in the scope of delivery)
Towing equipment Trailer turntable
Drawbar with tested 40 mm drawbar eye
Axles + suspension
SAF drum brake axles
Axle/chassis laser-measured Reduction in tire wear and fuel consumption
Parabolic suspension with maintenance-free steel-rubber bearings and mechanical axle load compensation
axle load compensation (rocker compensation)
Brake system
2-line compressed air brake system
Colored line routing for easy servicing.
Spring-loaded parking brake Incl.
2 swap-proof coupling heads at the front, with connecting lines to the motor vehicle,
ABS and ALB, with ABS plug at the front, with connecting cable,
Attention: The trailer may only be towed by towing vehicles that guarantee the effectiveness of the ABS!
Wheels and tires
235 / 75 R 17,5
at the choice of the manufacturer
Steel rims in twin arrangement, factory silver
Electrical system
24 volt, multi-chamber lights, amber LED lighting at the sides
2 white position lights at the front
2 white/red lane departure lights at the rear
2 x 7-pin interchangeable plugs at the front, with connecting cable,
1 LED rotating beacon with holder, switched via parking light (removable light)
2 pairs of warning signs, double LED illuminated and extendable to 3,000 mm
Floor
Front area steel floor,
then with 70 mm softwood floor, steel/checker plate flooring in the wheel housing area
Rear slope with 70 mm softwood floor
Deep loading area incl. rear slope 8,200 mm
Drive-on ramps
Steel ramps 2,800 mm long, 750 mm wide, can be moved sideways
Covered with wood Incl.
with spring lift support
Operating instructions
With an axle load of 10,000 kg, a special permit is required, only indivisible loads possible!!!
Hjdpfxei Riy Es Abzew
The specified total weight is technically possible; depending on the load, the total weight may not be achieved while complying with the permissible axle/support and fifth-wheel loads. (Poor driving and trailing behavior possible due to incorrect load distribution)
Country of registration / plates
Country of registration: Germany
with Dekra approval and expert opinion (according to §13 EG - FGV)
24/7 service hotline
Prepared for two-line license plate holder
Contour marking with reflective strips in accordance with ECE R 048, white on the sides and red on the rear
Paint finish
Frame DB 7350 nova gray
10-year warranty against rusting through
Drawbar Galvanized or black,
at the manufacturer's choice
Drive-on ramps Hot-dip galvanized
Attention: Archive pictures!

Annonsen ble oversatt automatisk. Oversettelsesfeil kan forekomme.